HOME    ABOUT US    DEALERS ONLY    RACING    WHERE TO BUY    CURRENT ADS    SHOWS    FAQ    PHOTO GALLERY    NEW ITEM    CONTACT US  
ArrowBODY ARMOR
   Frame Slider
   Axle Slider
   Clutch Protector
ArrowBRAKES
   Brake Line Kits
   Speed Bleeder®
   Custom Brake Lines
   Brake Line Accessories
   Brake Rotors
   Brake Pads
   Brake Fluid
   Spiegler Master Cylinders
   Radial Master Cylinders
   Brake Fluid Reservoir
   Quick Disconnect
   Tools
ArrowCONTROLS
   Handlebar Riser Kits
   Handlebar Riser Accessories
   Handlebar Rise Up Clamps
   Handlebar Tour Match Kits
   Levers
   Handlebars
   Fat-Bar Handlebars
   Handlebar Ends
   Clip-Ons
   S-Grips
   Rearsets
   Foot Pegs
   Mirror Gonia Mirror
   Handlebar End Mirror
   Steering Dampers
ArrowDRIVE TRAIN
   Sprockets
   AFAM/DC Chain
ArrowELECTRICAL
   LSL Urban Headlights
   Kellermann Turn Signals
   Motogadget
ArrowTriumph
   Select Triumph
   Esjot Sprockets
Please choose your bike here:
ESJOT is the exclusive OEM of Aprilia, KTM, BMW and others for sprockets!

ESJOT, ESJOT- Antriebstechnik GmbH is one of Germany's leading sprocket manufacturers. For over 80 years ESJOT has been designing and manufacturing high end sprockets using the finest materials. All aluminum sprockets are made from 7075 T6 and are hard anodized. This will increase the lifetime of the sprocket significantly. The steel for counter shaft sprockets and rear sprockets meets or exceeds highest OEM requirements. The high tensile strength of this material guarantees extreme long life.
DIAMOND CUT revolutionizes the sprocket technology. In cooperation with the University of Paderborn Germany, ESJOT has developed a new process to cut the teeth of chain driven sprockets. "Diamond cut" is an innovative manufacturing process resulting in a visible higher quality sprocket than has been possible on standard milled sprockets. Special tooling guarantees a super accurate cutting surfaces. At the same time the material is highly condensed in the area of the teeth flanges, so that in many cases additional heat treatment is no longer necessary. All sprockets are made from the best German steel or aluminum to obtain a continued high quality product.

Counter Shaft Sprockets Highest quality steel Mn CR5 of OEM quality is precision cut on CNC machines. Cutting the teeth with our "Diamond Cut" process and case hardening of 700 HV40 (case depth of 0.4mm) meets the highest quality. Modern milling machines guarantee a perfect fit on the drive shaft with tolerances of overall diameter and wobble remaining under 0.1mm.

Sprockets (rear) Center holes are precisely cut on CNC machines with extremely low tolerances. Only special steel qualities "Qste 420" and "Qste 460" are used. Mounting holes are countersunk and cleaned. Teeth are cut with the new special procedure "Diamond Cut", with tolerances of overall diameter and wobble of below 0.2mm which guarantees super smooth running.

© Copyright Spiegler Performance Parts. All rights reserved. Designed by: 512interactive LLC